Colorado 4WD L5-3.7L (2007)
6. Install the tire and wheel assembly.
7. Lower the vehicle.
8. Add brake fluid to the master cylinder if needed, so the fluid is between the maximum and minimum level.
9. Pump the brake slowly and firmly to seat the brake pads. Caution: Refer to Firm Brake Pedal Caution.
Important: The following service procedure may need to be repeated to obtain a firm brake pedal.
10. Pump the brakes slowly and firmly to seat the brake pads.
1. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
2. Slowly release the pedal.
3. Wait 15 seconds, apply the pressure to check for a firm pedal. This will properly seat the brake caliper pistons and brake pads.
11. Fill the master cylinder to the required level.
12. Burnish the new brake pads.
