Colorado 4WD L5-3.7L (2007)
Harness connector of reservoir tank
Brake pipes
Nut
Disconnect two brake pipes from the brake master cylinder.
Remove two nuts which fix the brake master cylinder to the vacuum booster.
Remove the brake master cylinder.
Install a new brake master cylinder.
Install two nuts which fix the brake master cylinder to the vacuum booster.
Tighten
Tighten the two fixing nuts to 10-16 N.m (7-12 lb ft).
Connect two brake pipes to the brake master cylinder.
Install the new fuel feeding tube to the plastic clip in the engine compartment.
Tighten
Tighten to 13-19 N.m (9-14 lb ft).
Connect a harness connector of the reservoir tank.
Connect (-) terminal connector of the battery.
Bleed the brake hydraulic circuit of air.*
