Colorado 4WD L5-3.7L (2007)
6. Remove the camshaft cover bolts.
7. Remove the camshaft cover from the cylinder head.
8. Remove and discard the seals from the camshaft cover. Do not reuse the seals.
9. Clean and inspect the cylinder head sealing surface.
Installation Procedure
1. Install a NEW camshaft cover seal into the camshaft cover groove.
2. Install NEW ignition coil seals into the camshaft cover grooves.
3. Place the camshaft cover to the cylinder head.
Notice: Refer to Fastener Notice.
4. Install the camshaft cover bolts.
Tighten the bolts to 10 N.m (89 lb in).
