Colorado 4WD L5-3.7L (2007)
1. Slide the multifunction switch/SIR coil assembly onto the steering column.
Notice: Refer to Fastener Notice.
2. Screw the 3 pan head tapping screws into the multifunction switch/SIR coil assembly.
Tighten the screws to 4.5 N.m (40 lb in).
3. Route the wire harness assembly down the steering column.
4. Connect the multifunction switch/SIR coil assembly connector at the base of the column.
5. Install the wire harness straps to the wire harness assembly.
6. Remove the centering tab from the multifunction switch/SIR coil assembly.
7. Install the steering column trim covers.
8. Install the steering wheel to the steering column.
9. Enable the SIR system. Refer to SIR Disabling and Enabling.
