Colorado 4WD L5-3.7L (2007)
seat and seatback.
2. Place the child restraint on the seat.
3. If the child restraint manufacturer recommends using a top tether anchor, attach the top tether on the child restraint to the top tether anchor on the
vehicle. Route the top tether according to the child restraint instructions and the following instructions:
1. Route the top tether over the center seatback or folding armrest, if equipped.
2. Attach the top tether to the slots in the back panel as shown. Do not tighten the top tether at this time.
4. Pick up the latch plate on the center position lap safety belt, and run the lap safety belt through the restraint. The child restraint instructions will
show you how.
5. Push the latch plate into the buckle until it clicks. Position the release button on the buckle so that the safety belt can be unbuckled.
6. Tighten the center position lap belt by pulling on the loose end of the belt. It may be helpful to use your knee to push down on the child restraint as
you tighten the belt.
7. Tighten the top tether. Follow the child restraint manufacturer's instructions.
8. Before placing a child in the child restraint, make sure it is securely held in place. To check, grasp the child restraint at the safety belt path and
attempt to move it side to side and back and forth. When the child restraint is properly installed, there should be no more than 2.5 cm (1 in) of
movement.
Courtesy Transportation
The General Motors Courtesy Transportation program is intended to minimize customer inconvenience when a vehicle requires a repair that is covered
by the New Vehicle Limited Warranties. The availability of courtesy transportation to customers whose vehicles are within the warranty coverage period
and involved in a product program is very important in maintaining customer satisfaction. Dealers are to ensure that these customers understand that
shuttle service or some other form of courtesy transportation is available and will be provided at no charge. Dealers should refer to the General Motors
Service Policies and Procedures Manual for Courtesy Transportation guidelines.
Warranty Transaction Information
Submit a transaction using the table below.
* The amount identified in Net Item should be the actual cost of a 2.5 in (63.5 mm) hole saw, not to exceed $15.00 USD, $15.04 CAD.
Customer Notification
General Motors did not notify customers involved in this recall. The customer names and addresses were not available. If a customer involved in this
recall comes into your dealership, please provide them with a copy of the customer letter included with this bulletin.
Dealer Recall Responsibility - For US (US States, Territories, and Possessions)
The US National Traffic and Motor Vehicle Safety Act provides that each vehicle that is subject to a recall of this type must be adequately repaired
within a reasonable time after the customer has tendered it for repair. A failure to repair within sixty days after tender of a vehicle is prima facie evidence
of failure to repair within a reasonable time. If the condition is not adequately repaired within a reasonable time, the customer may be entitled to an
identical or reasonably equivalent vehicle at no charge or to a refund of the purchase price less a reasonable allowance for depreciation. To avoid having
to provide these burdensome remedies, every effort must be made to promptly schedule an appointment with each customer and to repair their vehicle as
soon as possible if requested by the customer. In the recall notification letters, customers are told how to contact the US National Highway Traffic Safety
Administration if the recall is not completed within a reasonable time.
