Colorado 4WD L5-3.7L (2007)
1. Install the evaporator temperature sensor to the evaporator core. Place the sensor approximately 3.5 cm (1.4 in) from the side (a) and 5 cm (2 in)
from the bottom (b) corner of the evaporator core.
Important: Improper wire alignment will pinch and may cut the sensor wires.
2. Align the evaporator temperature sensor wires with the opening in the upper HVAC module case.
3. Install the evaporator core.
4. Cut the evaporator temperature sensor from the replacement assembly.
5. Connect the original sensor wire to the replacement assembly.
6. Connect the electrical connector to the evaporator temperature control module.
Notice: Refer to Fastener Notice.
7. Install the mounting screw to the control module.
Tighten the screw to 1.9 N.m (17 lb in).
8. Install the radio.