Colorado 4WD L5-3.7L (2007)
Notice: Refer to Component Fastener Tightening Notice.
1. Install the transfer case 2/4 indicator switch (4) and gasket (3) into the transfer case.
Tighten the 2/4 indicator switch to 39 N.m (29 lb ft).
2. Route the 2/4 indicator switch pigtail along the bracket (1)
3. Install the switch connector bracket bolt.
Tighten the switch connector bracket bolt to 15 N.m (11 lb ft).
4. Connect the gray 2/4 indicator switch electrical connector (2) to the bracket (1).
5. Connect the gray engine wiring harness electrical connector (2) to the gray 2/4 indicator switch electrical connector (4).
6. Lower the vehicle.