Colorado 4WD L5-3.7L (2007)
12. Remove the steering knuckle assembly from the vehicle and set on a bench.
13. Remove the ball joint using the J 6627-A.
14. Remove the wheel hub and bearing assembly.
Installation Procedure
1. Install the wheel hub and bearing assembly.
2. Clean all grease and contaminants from the tapered section and the threads of the upper ball joint, the lower ball joint, and the tie rod end.
3. Clean and inspect the taper holes and the mounting surfaces of the steering knuckle. If any of the tapered holes are elongated, out of round, or
damaged, replace the steering knuckle.
Notice: Refer to Fastener Notice.
4. Connect the lower ball joint to the steering knuckle and install the retaining nut.
Tighten the nut to 145 N.m (107 lb ft).
