Colorado 4WD L5-3.7L (2007)
3. Remove the propeller shaft.
-
For vehicles equipped with one piece propeller shafts, refer to Propeller Shaft Replacement - One Piece.
-
For vehicles equipped with two piece propeller shafts, refer to Propeller Shaft Replacement - Two Piece.
4. Measure the amount of torque required to rotate the pinion. Use an inch-pound torque wrench. Record this measurement for reassembly. This will
give the combined preload for the following components:
-
The pinion bearings
-
The pinion oil seal
-
The differential case bearings
-
The axle bearings
-
The axle seals
5. Place an alignment mark between the pinion and the pinion yoke.
