Colorado 4WD L5-3.7L (2007)
Important: Drive the seal in straight, not at an angle, as this will damage the aluminum housing.
2. Install the new oil seal by doing the following:
1. Position the oil seal in the bore.
2. Install the J 21128 over the oil seal.
3. Strike the J 21128 with a hammer until the seal flange seats on the axle housing surface.
3. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the splines of the drive pinion yoke.
4. Install the pinion yoke.
Align the reference marks made during removal.
Notice: Do not hammer the pinion flange/yoke onto the pinion shaft. Pinion components may be damaged if the pinion flange/yoke is hammered
onto the pinion shaft.
5. Seat the pinion yoke onto the pinion shaft by tapping it with a soft-faced hammer until a few pinion shaft threads show through the yoke.
6. Install the washer and a new pinion nut.
7. Install the J 8614-01 (1) onto the pinion yoke as shown.
Notice: Refer to Fastener Notice.
Important: If the rotating torque is exceeded, the pinion will have to be removed and a new collapsible spacer installed.
8. Tighten the pinion nut while holding the J 8614-01 (1).
Tighten the pinion nut until the pinion end play is just taken up. Rotate the pinion while tightening the nut to seat the bearings.
9. Measure the rotating torque of the pinion using an inch-pound torque wrench.
Compare the measurement of the rotating torque to the measurement recorded earlier.
The rotating torque of the pinion nut should be 0.40-0.57 N.m (3-5 lb in) greater than the torque recorded during removal.
10. If the rotating torque is not within specifications, continue to tighten the pinion nut.
Tighten the pinion nut, in small increments, as needed, until the torque required in order to rotate the pinion is 0.40-0.57 N.m (3-5 lb in)
greater than the torque recorded during removal.
11. Once the specified torque is obtained, rotate the pinion several times to ensure the bearings have seated. Recheck the rotating torque and adjust if
necessary.
12. Install the front propeller shaft.
13. Install the EPS.
14. Install the brake calipers.
15. Inspect the axle lubricant level, and add, if necessary. Refer to Lubricant Replacement - Front Drive Axle.
16. Lower the vehicle.
Differential Carrier Assembly Cover and/or Gasket Replacement
Differential Carrier Assembly Cover and/or Gasket Replacement
Removal Procedure
