Colorado 4WD L5-3.7L (2007)
Seals and Gaskets: Service and Repair
Rear Drive Axle
Rear Axle Shaft Seal and/or Bearing Replacement
Rear Axle Shaft Seal and/or Bearing Replacement
Tools Required
^
J 8092 Universal Driver Handle- 3/4 in - 10
^
J 21128 Axle Pinion Oil Seal Installer
^
J 23690 Bearing Installer
^
J 2619-01 Slide Hammer
^
J 44685 Rear Axle Seal and Bearing Remover
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel assembly.
3. Remove the axle shaft.
4. Using the J 44685 and the J 2619-01, remove the axle shaft bearing and seal.
Installation Procedure
1. Using the J 23690 and the J 8092, install the axle bearing.
2. Using the J 21128, install the axle shaft seal.
3. Install the axle shaft.
4. Install the tire and wheel assembly.
5. Fill the rear axle with axle lubricant. Use the proper fluid. Refer to Lubricant Replacement - Rear Drive Axle (8.0/8.6 Inch Axle).
6. Lower the vehicle.
Drive Pinion Flange/Yoke and/or Oil Seal Replacement
Drive Pinion Flange/Yoke and/or Oil Seal Replacement
Tools Required
^
J 8614-01 Flange and Pulley Holding Tool
^
J 33782 Pinion Oil Seal Installer
^
J 38694 Extension Housing Oil Pump/Seal Installer
Removal Procedure
