Colorado 4WD L5-3.7L (2007)
4. Measure the amount of torque required to rotate the pinion. Use an inch-pound torque wrench. Record this measurement for reassembly. This will
give the combined preload for the following components:
-
The pinion bearings
-
The pinion oil seal
-
The differential case bearings
-
The axle bearings
-
The axle seals
5. Place an alignment mark between the pinion and the pinion yoke.
6. Install the J 8614-01 as shown.
7. Remove the pinion nut while holding the J 8614-01.
8. Remove the washer.
9. Install the J 8614-3 (2) and the J 8614-2 (3) into the J 8614-01 (1) as shown.
