Colorado 4WD L5-3.7L (2007)
1. Install the park/neutral back up switch to the transmission manual shaft by aligning the switch hub flats with the manual shaft flats.
2. Slide the switch onto the transmission manual shaft until the switch mounting bracket contacts the mounting bosses on the transmission.
Important: If a new switch is being installed, the switch will come with a positive assurance bracket. The positive assurance bracket aligns
the new switch in the proper position for installation and the use of the J 41364-A will not be necessary.
3. Loosely install the 2 park/neutral back up switch bolts.
4. Position the J 41364-A onto the park/neutral back up switch. Ensure that the 2 slots on the switch where the manual shaft is inserted are lined up
with the lower 2 tabs on the tool.
Notice: Refer to Fastener Notice.
5. Rotate the switch until the upper locator pin on the tool is lined up with the slot on the top of the switch.
Tighten the park/neutral back up switch bolts 27 N.m (20 lb ft).
6. Remove the J 41364-A from the switch. If installing a new switch, remove the positive assurance bracket at this time.
