Colorado 4WD L5-3.7L (2007)
Gear Sensor/Switch: Service and Repair
Transfer Case Encoder Motor Replacement
Transfer Case Encoder Motor Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the following from the encoder motor (7):
-
The electrical connector (8)
-
The vent hose
3. Remove the encoder motor mounting bolts.
4. Remove the encoder motor (3) and O-ring seal (2) from the transfer case.
Discard the O-ring seal (2).
Installation Procedure
Important:
^
The actuator shaft in the transfer case may require rotating to the neutral position prior to installing the encoder motor.
^
Do not rotate the actuator shaft using the encoder motor.
