Colorado 4WD V8-5.3L (2010)
Engine Oil Dip Stick - Dip Stick Tube: Service and Repair
Oil Level Indicator Tube Replacement
Removal Procedure
1. Remove the cylinder number 2 spark plug and wire. Refer to Spark Plug Replacement (See: Tune-up and Engine Performance Checks/Spark
Plug/Service and Repair).
2. Remove the oil level indicator from the tube.
3. Remove the oil level indicator tube bolt.
4. Remove the oil level indicator tube from the engine block.
Note: The O-ring seal may be reused if not cut or damaged.
5. Inspect the O-ring seal for cuts or damage.
6. Remove the O-ring seal from the tube, if required.
Installation Procedure