Colorado 4WD V8-5.3L (2010)
Installation Procedure
Note:
*
The actuator shaft in the transfer case may require rotating to the neutral position prior to installing the encoder motor.
*
Do not rotate the actuator shaft using the encoder motor.
1. Lightly lubricate the NEW O-ring seal (2) with clean transfer case fluid.
2. Insert the O-ring seal (2) into the transfer case.
Note: Ensure the encoder motor is seated flat against the transfer case.
3. Position the encoder motor (3) to the transfer case, aligning the actuator shaft.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the encoder motor mounting bolts, with the heated oxygen sensor bracket (1).
Tighten the encoder motor mounting bolts to 22 Nm (16 lb ft).