Colorado 4WD V8-5.3L (2010)
1. Apply a 3 mm (1/8 in) bead of sealant GM P/N 89020326 (Canadian P/N 89021188) to the input shaft bearing retainer.
Note: Ensure the seal does not catch on the input shaft splines.
2. Position the input shaft bearing retainer to the transmission.
3. Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) to the threads of the input shaft bearing retainer bolts if new bolts are not
available.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the NEW input shaft bearing retainer bolts.
Tighten the input shaft bearing retainer bolts to 17 Nm (13 lb ft).
5. Install the clutch actuator cylinder. Refer to Clutch Actuator Cylinder Replacement (See: Clutch/Clutch Hydraulic System/Clutch Slave
Cylinder/Service and Repair).
6. Fill the transmission fluid. Refer to Transmission Fluid Replacement (See: Service and Repair/Removal and Replacement/Transmission Fluid
