Colorado 4WD V8-5.3L (2010)
Caution: Refer to Component Fastener Tightening Caution (See: Service Precautions/Vehicle Damage Warnings/Component Fastener
Tightening Caution).
1. Install the transfer case NEUTRAL switch (1) and gasket (4) into the transfer case.
Tighten the neutral switch to 39 Nm (29 lb ft).
2. Connect the brown NEUTRAL switch electrical connector (2) to the bracket (3).
3. Connect the brown engine wiring harness electrical connector (1) to the brown NEUTRAL switch electrical connector (6).
4. Lower the vehicle.