Colorado 4WD V8-5.3L (2010)
Caution: Refer to Component Fastener Tightening Caution (See: Service Precautions/Vehicle Damage Warnings/Component Fastener
Tightening Caution).
1. Install the transfer case 2/4 indicator switch (4) and gasket (3) into the transfer case.
Tighten the 2/4 indicator switch to 39 Nm (29 lb ft).
2. Route the 2/4 indicator switch pigtail along the bracket (1)
3. Install the switch connector bracket bolt and tighten to 15 Nm (11 lb ft).
4. Connect the gray 2/4 indicator switch electrical connector (2) to the bracket (1).
5. Connect the gray engine wiring harness electrical connector (2) to the gray 2/4 indicator switch electrical connector (4).
6. Lower the vehicle.