Corsica L4-121 2.0L (1988)
or use excessive force. If pinion and valve assembly don no( fully sent in housing, check to be sure valve body rings am not binding in housing
bon. Cbeck rings for cuts or damage. Repent installation steps 1 through 5. If pinion and Valve assembly will not align properly in housing bore,
replace rack and pinion assembly.
Inspect
When pinion and valve assembly is fully seated, flat or notch in stub shaft and first mark on housing must line up while the rack is centered in the
housing. Refer to measurement "A" to verify proper rack
Figure 12 - Seal Installation
7.
While holding the stub shaft, thread lock nut onto pinion and torque to 35 N-m (26 Lbs.Ft.).
v Important
If the stub is not held, damage to the pinion teeth will occur.
8.
Install dust cover to housing.
9.
Install stub shaft bearing annulus onto stub shaft.
10.
Place seal protector J 29810 onto stub shaft.
11.
Install stub shaft seal and stub shaft dust seal over protector and into housing. (Apply a small quantity of grease between seals and on top of dust
seal.)
