Corsica L4-134 2.2L (1991)
Resistor Module (SIR): Service and Repair
Fig. 324 Resistor Module Replacement
1.
Deactivate airbag system as described under MAINTENANCE PROCEDURES/AIRBAG DEACTIVATION.
2.
Remove tape securing resistor module to wiring harness.
3.
Remove CPA and disconnect resistor module electrical connector.
4.
Remove resistor module, Fig. 324.
5.
Reverse procedure to install, noting the following:
a. Following installation, activate airbag system as described under MAINTENANCE PROCEDURES/AIRBAG ACTIVATION.
b. Turn ignition switch to the On position and verify the ``Inflatable Restraint'' indicator flashes 7 to 9 times then turns Off. If indicator does not
respond, refer to DIAGNOSIS AND TESTING PROCEDURE/TESTING PROCEDURES/RETRIEVING TROUBLE CODES.
