Corsica L4-2.2L VIN 4 (1995)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor
REMOVE OR DISCONNECT
1. Raise vehicle and suitably support.
2. Crankshaft Position (CKP) sensor harness connector at module.
3. CKP sensor mounting bolt.
4. CKP sensor from engine.
Inspect
Sensor O-ring for wear, cracks or leakage. Replace if necessary. Lube new O-ring with engine oil before installing.
INSTALL OR CONNECT
1. CKP sensor into block.
2. CKP sensor mounting bolt.
Tighten
CKP sensor mounting bolt to 8 Nm (71 lb in).
3. CKP sensor harness connector.
4. Lower vehicle.
