Corsica V6-191 3.1L (1990)
NOTE: If any parts are of doubtful strength or quality due to discoloration from heat, over-stress, or are worn, the parts should be replaced.
13. Clean adjusting screw assembly and threads with a wire brush. It must be disassembled and thoroughly cleaned.
14. Wash all components in clean denatured alcohol.
15. Apply brake lubricant PN 5450032 or equivalent to the adjusting screw threads, inside diameter of socket and socket face. Adequate lubrication is
achieved when a continuous bead of lubricant is at open end of pivot nut and socket when threads are fully engaged. Inspect threads of adjusting
screw for smooth rotation over full length.
INSTALL OR CONNECT
1. Parking brake lever on secondary shoe with pin and retaining ring.
2. Adjusting screw assembly and spring.
3. Shoe and lining assemblies after attaching parking brake cable.
4. Parking brake strut and strut spring by spreading shoes apart. To be properly positioned:
^
The end without the spring should engage the parking brake lever and secondary shoe and lining.
^
The end with the spring should engage the primary shoe and lining.
5. Actuator lever and lever return spring.
6. Hold-down pins, lever pivot and hold-down springs.
7. Actuator link on anchor pin.
8. Actuator link into actuator lever while holding up on lever.
9. Shoe return springs using J-8057 pliers.
10. Brake drum.
11. Tire and wheel assembly.
12. Lower vehicle.
13. Torque wheel nuts to 140 Nm (100 ft lbs).
