Corsica V6-3100 3.1L MFI VIN M (1994)
4. Align crankshaft timing mark to timing mark on bottom of chain damper.
5. Hold car sprocket with the chain hanging down and install chain to crankshaft gear.
6. Align timing mark on camshaft gear (center line of locator hole) with timing mark on top of chain damper.
7. Camshaft sprocket bolt/screw (91).
Tighten bolts/screws (91) to 100 Nm (74 lb. ft.).
8. Timing chain dampener (51) and bolts/screws (50).
Tighten bolts/screws (50) to 25 Nm (18 lb. ft.).
9. Engine front cover assembly.
INSTALL OR CONNECT WITHOUT TIMING MARKS
This article has been updated with bulletin No.: 47-61-48.
REVISED TIMING CHAIN AND SPROCKET INSTALLATION PROCEDURE
^
If the camshaft gear does not have a timing mark, use the following procedure.
TOOLS REQUIRED: J 38612 Crankshaft Sprocket Installer.
INSTALL OR CONNECT
1. Crankshaft sprocket using J 38612.
2. Apply GM EOS P/N 1052367 or equivalent to the sprocket thrust surface.
