Corsica V6-3100 3.1L VIN M SFI (1996)
Compressor Clutch Hub: Service and Repair
Conventional Mounted
Removing Shaft Nut
Clutch Plate And Hub Assembly Removal
Remove or Disconnect
1. Clamp the holding fixture J 34992 in a vise and attach compressor to holding fixture with thumb screws J 34992-1.
2. Keep the clutch hub and drive plate assembly from turning by using the clutch hub holding tool J 33027-A. Remove the shaft nut using shaft nut
socket J 33022.
3. Thread the Clutch Plate and Hub Assembly Remover J 33013-B into the hub. Hold the body of the remover with a wrench and turn the center
screw into the remover body to remove the clutch plate and hub assembly.
4. Remove the shaft key and retain for reassembly.
