Corsica V6-3100 3.1L VIN M SFI (1996)
Fuel Injector: Service and Repair
REMOVE OR DISCONNECT
CAUTION: Use care in removing the fuel injectors to prevent damage to the fuel injector electrical connector pins or the fuel injector nozzles.
The fuel injector is an electrical component and should not be immersed in any type of cleaner as damage to the fuel injector may result.
NOTE: Important the fuel injector is serviced as a complete assembly only. If the fuel injectors are found to be leaking, the engine oil may be
contaminated with fuel.
1. Relieve fuel system pressure.
2. Remove the upper intake manifold.
3. Remove the fuel rail.
4. Remove the fuel injector retaining clips.
5. Remove the fuel injectors.
INSTALLATION
NOTE: Important each fuel injector is calibrated for a specific flow rate. Be sure to use the correct part number when ordering replacement fuel
injectors. When replacing the fuel injector O-Rings, be sure to install the brown O-Ring in the lower position. The fuel injector lower O-Ring uses
a nylon collar, called the O-Ring backup, to properly position the O-Ring on the fuel injector. Be sure to reinstall the O-Ring backup, or the
sealing O-Ring may move on the fuel injector when installing the fuel rail. If the sealing O-Ring is not seated properly, a vacuum leak is possible
and driveability complaints may occur.
1. Install the fuel injector Upper O-Ring (1).
2. Install the fuel injector lower O-Ring Backup (4).
3. Install the fuel injector lower O-Ring (5).
4. Install the fuel injector (3) to fuel rail.
5. Install the fuel injector retaining clips (2).
6. Install the fuel rail.
7. Install the upper intake manifold
8. Install the fuel filler cap.