Corvette V8-5.7L VIN G (1997)
Coaxial Cable Replacement (Radio Control): Installation Procedure
6. Install the radio control retaining screws.
Tighten
Tighten the radio control retaining screws to 2.5 N.m (22 lb in).
NOTE: Refer to Fastener Notice in General Information.
Coaxial Cable Replacement (Radio Control): Installation Procedure
7. Install the ignition switch to the ignition switch housing bracket.
8. Install the ignition switch retaining bolts.
Tighten
Tighten the ignition switch retaining bolts to 5.5 N.m (49 lb in).
9. Install the ignition switch bezel to the switch. Align the bezel slots to the switch pins, then push to secure.
Coaxial Cable Replacement (Radio Control): Installation Procedure
10. Install the coaxial cable to the insulation tape along the hinge pillar.
11. Install the LH I/P lower insulator panel.