Corvette V8-5.7L VIN G (1997)
Inside Door Handle Replacement: Installation Procedure
4. Slide the forward end of the handle into the mounting slots in the door.
5. Snap the rear of the handle to the door.
6. Install the screw attaching the handle.
Tighten
Tighten the inside handle screw to 5 N.m (44 lb in).
NOTE: Refer to Fastener Notice in General Information.
7. Snap the lock rods into the anti-rattle retainer at the black mark on the rod anti raffle sleeve.
Inside Door Handle Replacement: Installation Procedure
8. Install the water deflector.
Inside Door Handle Replacement: Installation Procedure
9. Install the door trim panel.