Corvette V8-5.7L VIN G (1997)
4. Remove the brake caliper guide pin bolts.
5. Remove the brake caliper housing from the brake rotor and the brake caliper mounting bracket.
6. If a brake caliper housing overhaul or replacement is not required, support the brake caliper housing using a wire hook or equivalent to avoid
damage to the brake hose.
7. Remove the brake pads only if they are being replaced or if the brake caliper mounting bracket is being removed.
INSTALLATION PROCEDURE
1. Install the brake pads, if removed.
a. Install the outboard brake pad with the insulator installed toward the brake caliper housing.
b. Install the inboard brake pad with the wear sensor installed nearest the brake caliper piston.
c. The wear sensor must be in the trailing position during forward wheel rotation.
2. Install the brake caliper housing over the brake rotor and into the brake caliper mounting bracket.
3. Install the brake caliper guide pin bolts.
-
Tighten the brake caliper guide pin bolts to 31 Nm (23 ft. lbs.).
CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement, or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and system.
4. Install the inlet fitting, two new gaskets and the inlet fitting bolt, if removed.
-
Tighten the brake caliper inlet fitting bolt to 40 Nm (30 ft. lbs.).
5. Bleed the hydraulic brake system, If the inlet fitting was removed. Refer to Hydraulic Brake System Bleeding in Hydraulic Brakes.
6. Install the tire and wheel assembly.
-
Tighten the wheel nuts in sequence to 140 Nm (100 ft. lbs.).
7. Lower the vehicle.
8. Refill the master cylinder reservoir.
9. With the engine running, pump the brake pedal slowly and firmly three times to seat the brake pads.
10. Inspect the hydraulic brake system for brake fluid leaks.
