Corvette V8-5.7L VIN G (1997)
CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement, or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and system.
4. Install the inlet fitting, two new gaskets and the inlet fitting bolt, if removed.
-
Tighten the brake caliper inlet fitting bolt to 40 Nm (30 ft. lbs.).
5. Bleed the hydraulic brake system, If the inlet fitting was removed. Refer to Hydraulic Brake System Bleeding in Hydraulic Brakes.
6. Install the tire and wheel assembly.
-
Tighten the wheel nuts in sequence to 140 Nm (100 ft. lbs.).
7. Lower the vehicle.
8. Refill the master cylinder reservoir.
9. With the engine running, pump the brake pedal slowly and firmly three times to seat the brake pads.
10. Inspect the hydraulic brake system for brake fluid leaks.
Rear
REMOVAL PROCEDURE
1. Raise the vehicle and support.
2. Remove the tire and wheel assembly.
3. Remove the inlet fitting bolt, inlet fitting and two gaskets only if the brake caliper housing is being removed from the vehicle.
a. Discard the two gaskets.
b. Plug the openings in the brake caliper housing and the inlet fitting.
