Corvette V8-5.7L VIN G (1997)
Engine Mount: Service and Repair
Removal
CAUTION: Use Only J 41803 Engine Support Fixture when supporting the engine. Do not jack anywhere on the engine or vehicle damage could result.
^
Tools Required or equivalent:
J 33432-A - Transverse Leaf Spring Compressor.
J 42188 - Ball Joint Separator.
J 41803 - Engine Support Fixture.
1. Disconnect the negative battery cable.
2. Visually inspect the mounts for damage.
3. Remove the generator from the accessory mounting bracket.
4. Support the engine using a Engine Support Fixture.
5. Raise the vehicle and support.
6. Remove the front tire and wheel assemblies.
7. Remove the tie rod end nuts (3).
8. Remove the tie rod ends (5) from the steering knuckles (4) using a Ball Joint Separator.
9. Remove the stabilizer bar bolts and straps.
