Corvette V8-5.7L VIN G (1997)
2.1.
Use a twisting motion to secure the duct to the duct muffler.
2.2.
Install the duct retaining tab to the ignition switch housing bracket.
3. Install the Instrument Panel Cluster (IPC) into position.
4. Install the IPC to steering column bracket bolts.
Tighten
Tighten the IPC to steering column bracket retaining screws to 3.5 N.m (31 lb in).
NOTE: Refer to Fastener Notice in General Information.
5. Install the I/P upper trim pad.
6. Install the driver knee bolster trim panel.
7. Install the I/P accessory trim plate.
Install the console.
Windshield Defroster Duct Replacement
REMOVAL PROCEDURE
Windshield Defroster Duct Replacement: Removal Procedure
1. Remove the I/P upper trim pad.
2. Remove the DRL and sunload temperature sensor wire retainers from the windshield defroster duct, if equipped.
3. Remove the windshield defroster duct retaining screws.
4. Release the windshield defroster duct from the LH and RH side window lower defogger outlet ducts.
Lift the windshield defroster duct slightly, then use a twisting motion to release from the side window lower defogger ducts.
5. Remove the defroster duct.
INSTALLATION PROCEDURE
Windshield Defroster Duct Replacement: Installation Procedure
