Corvette V8-5.7L VIN G (1997)
Headlamp Control Module Replacement: Installation Procedure
3. Connect the electrical connectors to the module.
Headlamp Control Module Replacement: Installation Procedure
4. Position the brake caliper cooling duct to the front fascia and push to secure.
5. Install the front fascia lower closeout panel.
Headlamp Control Module Replacement: Installation Procedure
7. Connect the RH headlamp wiring harness electrical connector to the forward lamp wiring harness.
8. Lower the RH headlamp manually. Turn the manual headlamp control knob clockwise.
9. Connect the negative battery cable.
Tighten
Tighten the negative battery cable bolt to 15 N.m (11 lb ft).
NOTE: Refer to Fastener Notice in General Information.
