Corvette V8-5.7L VIN G (1997)
Tire Pressure Sensor: Service and Repair
Removal Procedure
1. Raise the vehicle on a suitable support.
2. Remove the tire and wheel assembly.
3. Remove the tire from the wheel.
4. Remove the TPM sensor nut.
5. Remove the TPM sensor.
Installation Procedure
1. Position the sensor.
2. Install the sensor nut.
-
Tighten the nut to 12 Nm (106 inch lbs.).
Notice: Always use the correct fastener In the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases,
or other corrosion Inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque
and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications.
Following these instructions can help you avoid damage to parts and system.
3. Install the tire on the wheel.
4. Install the tire and wheel.
5. Lower the vehicle.
6. Program the TPM sensors. Refer to TPM Sensor Programming.
