Corvette V8-5.7L VIN G (1997)
Throttle Position Sensor: Service and Repair
REMOVAL PROCEDURE
1. Disconnect the TP sensor electrical connector.
2. Remove the TP sensor attaching screws.
3. Remove the TP sensor.
NOTICE: The TP sensor is an electrical component. Do not soak the TP sensor in any liquid cleaner or solvent as damage may result.
INSTALLATION PROCEDURE
1. Install the TP sensor on the throttle body with the throttle valve in the closed position. Make sure the TP sensor lever lines up with the TP sensor
drive lever on the throttle shaft.
2. Install the TP sensor attaching screws. Tighten the TP sensor attaching screws to 2 Nm (18 lb. in.).
3. Connect the TP sensor electrical connector.
