chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

ABOUT US
Ignition Switch > < Crankshaft Position (CKP) Sensor and Reluctor Wheel|Page 4156

Corvette V8-5.7L VIN G (1997)

Page 2
background image

6. Remove the CKP sensor retaining bolt.
7. Remove the CKP sensor.

INSTALLATION PROCEDURE

1. Install the CKP sensor.
2. Install the CKP sensor retaining bolt. Tighten the CKP sensor to 25 Nm (18 lb. ft.).
3. Connect the CKP sensor electrical connector.
4. Install the starter.
5. Connect the starter electrical connectors.
6. Lower the vehicle.
7. Connect the negative battery cable.

Ignition Switch > < Crankshaft Position (CKP) Sensor and Reluctor Wheel|Page 4156