Corvette V8-5.7L VIN G (1997)
7. Remove the EBTCM LH mounting bracket with the EBTCM rubber insulators. (The EBTCM insulators will remain attached to the LH mounting
bracket.)
8. Pull lightly to release the EBTCM from the insulator attached to the RH mounting bracket.
9. Tie off the EBTCM to the underbody to support out of the way.
10. Remove the rear transverse spring.
11. Disconnect the wiring harness and brake pipe clip retainers from the rear suspension crossmember.
12. Position a transmission jack under the rear suspension crossmember and firmly secure the crossmember to the jack.
13. BY HAND, remove the rear suspension crossmember mounting nuts.
Important: Observe the clearance between the driveline and the driveline tunnel closeout panel.
14. Slowly lower the rear suspension crossmember, along with the attached driveline, approximately 38 mm (1.5 inches). (Lower the rear suspension
crossmember and driveline for access to the reverse lockout solenoid.)
