Corvette V8-5.7L VIN G (1997)
Daytime Running Lamp Control Unit: Service and Repair
REMOVAL PROCEDURE
DRL Control Module (Canada): Removal Procedure
CAUTION: Refer to Battery Disconnect Caution in General In formation.
1. Disconnect the negative battery cable.
2. Remove the driver knee bolster trim panel.
3. Disconnect both of the Connector Position Assurance (CPA).
4. Disconnect the DRL module electrical connectors.
DRL Control Module (Canada): Removal Procedure
5. Remove the DRL module from the I/P center support bracket. Release the tabs, then pull down on the module to release.
INSTALLATION PROCEDURE