Corvette V8-5.7L VIN G (1997)
1. Loosen the jam nut on the tie rod.
2. Rotate the inner tie rod to the required toe specification setting.
3. Tighten the jam nut on the tie rod.
Notice: Always use the correct fastener In the proper location. When you replace a fastener, use ONLY the exact part number for that application.
The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that
require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other
corrosion Inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and system
-
Tighten the front tie rod jam to 68 Nm (50 ft. lbs.).
4. Recheck the toe setting after tightening.
5. Readjust the toe setting if necessary.
