Corvette V8-5.7L VIN G (1997)
^
Test Terminated Sequence 3 Not applicable.
Depending on the condition, different messages may be displayed in Sequence 4.
^
Test Terminated Sequence 4 "Test Terminated" or "Check for automatic transmission (non-export) steering wheel theft deterrent lock shorting
harness" being installed.
The harness is only for use on non-export vehicles with automatic transmissions. It is NOT for use on manual transmission vehicles. If the
harness has been installed, it must be removed. If the harness is not to there, replace the ECL.
^
Test Terminated Sequence 5 "Test Terminated"
Check for the automatic transmission (non-export) steering wheel theft deterrent lock shorting harness being installed. The harness is only for
use on non-export vehicles with automatic transmissions. It Si NOT for use on manual transmission vehicles or EXPORT automatic
transmission vehicles. If the harness has been installed, it must be removed. If the harness is not there, replace the ECL.
Lock Plate, Retaining Ring, and Nut Replacement
The following procedure should only be performed if the results of the Functional Test direct you to this section.
^
J 1859-A Steering Wheel Puller
^
J 42120 Steering Wheel Puller Legs
^
J 23653-SIR Steering Column Lock Plate Compressor
1.
Turn the ignition switch to the OFF position.
2.
Disconnect the negative battery cable.
3.
Disengage the upper latches or hook and loop fasteners on the front floor kick-up panel on the passenger side.
4.
Lift the kick-up panel's lower edge out of the slots in the relay bracket.
5.
Remove the SDM fuse from the IP fuse block located behind the kick-up panel that was just removed.
6.
Using a flat-bladed tool, carefully pry the IP courtesy lamp assembly from the driver's side lower closeout.
