Corvette V8-5.7L VIN G (1997)
18.
Using a small flat-bladed screwdriver, release the locking tab from the tilt lever handle and pull the lever straight out.
19.
Using a small flat-bladed screwdriver, pry the lower edge of the combination fog lamp/trunk release switch to release the locking tab. Disconnect
the electrical connector from the switch. Repeat this step on the inside air temperature grill located to the right side of the steering column.
Important:
When removing the driver's side knee bolster trim panel as described below, care must be taken not to damage the console trim plate as the
knee bolster trim panel tucks in behind the console trim plate.
20.
Remove the driver's side knee bolster trim panel retaining screw, located behind the area where the combination fog lamp/trunk release switch is
installed.
Repeat this step on the screw located in the inside air temperature cavity.
21.
Remove the driver's side knee bolster trim panel lower retaining screws.
22.
Grasp the trim panel at the side edges and firmly pull rearward to release the locking tabs and remove the panel.
23.
If equipped, disconnect the electrical connector from the inside air temperature sensor.
