Corvette V8-5.7L VIN G (1997)
Important:
When removing the driver's side knee bolster trim panel as described below, care must be taken not to damage the console trim plate as the
knee bolster trim panel tucks in behind the console trim plate.
20.
Remove the driver's side knee bolster trim panel retaining screw, located behind the area where the combination fog lamp/trunk release switch is
installed.
Repeat this step on the screw located in the inside air temperature cavity.
21.
Remove the driver's side knee bolster trim panel lower retaining screws.
22.
Grasp the trim panel at the side edges and firmly pull rearward to release the locking tabs and remove the panel.
23.
If equipped, disconnect the electrical connector from the inside air temperature sensor.
24.
Remove the two screws that attach the lower steering column cover (3) to the upper (1).
25.
Remove the one screw that attaches the upper steering column cover to the column and remove the upper cover.
26.
Remove the snap ring and SIR coil from the steering column.
