Corvette V8-5.7L VIN G (1997)
16.
Using tool J 1859-A, Steering Wheel Puller, and J 42120, Steering Wheel Puller Legs, remove the steering wheel from the column.
17.
Using a small flat-bladed screwdriver, release the locking tab from the tilt lever handle and pull the lever straight out.
18.
Using a small flat-bladed screwdriver, pry the lower edge of the combination fog lamp/trunk release switch to release the locking tab. Disconnect
the electrical connector from the switch. Repeat this step on the inside air temperature sensor grill located to the right side of the steering column.
Important:
When removing the driver's side knee bolster trim panel as described below, care must be taken not to damage the console trim plate as the
