Corvette V8-5.7L VIN G (1997)
12. Disconnect both of the stabilizer bar links from the lower control arms. See: Suspension/Stabilizer Bar/Stabilizer Link
13. Remove the stabilizer bar from the crossmember.
14. Remove the steering gear mounting bolts and nuts.
15. Remove the power steering gear from the vehicle through the left wheelhouse opening.
Installation Procedure
1. Install the power steering gear into the vehicle through the left wheelhouse opening.
2. Install the power steering gear mounting bolts and nuts.
-
Tighten the steering gear mounting nuts to 100 Nm (74 ft. lbs.).
Notice: Always use the correct fastener In the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases,
or other corrosion Inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque
and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications.
Following these instructions can help you avoid damage to parts and systems.
3. Install the stabilizer bar onto the crossmember.
4. Connect both of the stabilizer bar links onto the lower control arms. See: Suspension/Stabilizer Bar/Stabilizer Link
5. Connect both outer tie rods to the knuckles. Refer to Outer Tie Rod End.
-
Tighten the outer tie rod nut to the knuckle to 45 Nm (33 ft. lbs.).
6. Connect the lower steering coupling onto the power steering gear. See: Steering Column
7. Connect the electrical connector for MAGNASTEER.
