chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Recall - Rear Suspension Tie Rod Assembly May Fracture|Page 9591 > < Recall - Rear Suspension Tie Rod Assembly May Fracture|Page 9589
Page 3
background image

10.

Reinstall vibration damper on transmission. Torque to 25 Nm (18 lb. ft.).

11.

Reinstall both mufflers (care should be taken when installing gaskets). Torque flange bolts to 50 Nm (37 lb. ft.), and rear hanger bolts to 50 Nm
(37 lb. ft.).

12.

Reinstall stabilizer shaft. Torque fasteners to:

Upper Bolts - 65 Nm (49 lb. ft.)
Lower Nuts - 95 Nm (70 lb. ft.).

13.

Reinstall both tire and wheel assemblies using an impact wrench and a torque limiting socket in the star pattern.

14.

Check and/or set front and rear toe alignment. Torque tie rod jam nuts 68 Nm (50 lb. ft.).

REAR SUM TOE 0.00 Degree +/- 0.20
REAR CAMBER -0.25 Degrees +/- 0.50 per Wheel

FRONT SUM TOE+0.10 Degree +/- 0.20
FRONT CAMBER5 Degree +/- 0.50
FRONT CASTER +6.50 Degree /- 0.50 per Wheel

15.

Install the GM Campaign Identification Label.

16.

Vehicle is eligible for HAND wash if acceptable to owner.

Campaign Identification Label

Each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label".
Each label provides a space to include the campaign number and the five (5) digit dealer code of the dealer performing the campaign service. This
information may be inserted with a typewriter or a ball point pen.

Each "Campaign Identification Label" is to be located on the radiator core support in an area which will be visible when the vehicle is brought in by the
customer for periodic servicing. When installing the Campaign Identification Label, be sure to pull the tab to allow adhesion of the clear protective
covering. Additional Campaign Identification Labels can be obtained from VISPAC Incorporated by calling 1-800-269-5100 (Monday-Friday, 8:00 a.m.
to 4:30 p.m. EST). Ask for Item Number S-1015 when ordering.

Apply the "Campaign Identification Label" only on a clean, dry surface.

Claim Information

Submit a Product Campaign Claim after APRIL 1, 1997 with the information indicated:

Refer to the General Motors Corporation Claims Processing Manual for details on Product Campaign Claim Submission.

Owner Letter

Recall - Rear Suspension Tie Rod Assembly May Fracture|Page 9591 > < Recall - Rear Suspension Tie Rod Assembly May Fracture|Page 9589