Corvette V8-5.7L VIN G (1997)
Windshield (Short): Installation Procedure
13. Apply a smooth continuous 4.0 mm (0.17 in) bead of adhesive directly to the old adhesive in the body opening.
Windshield (Short): Installation Procedure
14. Install the windshield:
14.1. Position the windshield in the body opening.
14.2. Hand press around the windshield periphery. Paddle the urethane as needed.
14.3. Tape the windshield into place.
Windshield (Short): Installation Procedure
15. Adjust the windshield stops.
Windshield (Short): Installation Procedure
16. Water test the windshield immediately.
^
Use a soft spray.
^
Use warm or hot water to accelerate the cure of the urethane adhesive.
^
DO NOT direct a hard stream of high pressure water at the fresh urethane adhesive.
^
If leaks are found, apply extra urethane at the leak points using a plastic paddle and then retest.
