Corvette V8-5.7L VIN G (1997)
3. Connect the electrical connector and the washer hose onto the washer pump.
Washer Pump/Reservoir Replacement: Installation Procedure
4. Connect the electrical connector onto the fluid level sensor.
5. Place the washer solvent container over the studs on the wheelhouse.
6. Install the washer solvent container nuts.
Tighten
Tighten the washer solvent container nuts to 7.5 N.m (66 lb in).
NOTE: Refer to Fastener Notice in General Information.
7. Fill the washer solvent container with washer solvent.
CAUTION: Refer to Battery Disconnect Caution in General in formation.
8. Connect the negative battery cable.