Corvette V8-6.0L VIN U (2005)
2. Install the cables to the two rear motors and to the adjuster.
3. Install the screws mounting the rear motors.
4. Install the front motor (forward and back motor) to the bracket.
5. Connect the harness electrical connector.
6. Position the bracket onto one adjuster transmission.
7. Insert the drive cable into the motor and then into the transmission. It may be necessary to turn the cable to get the cable to slide into the
transmission.
8. Repeat the 2 previous steps on the opposite side.
9. Bend the bracket ends outward enough to prevent the bracket from sliding off the transmissions.
10. Tie strap the lumbar pump to the torque tube, if equipped.
11. Install the seat.
