Corvette V8-6.0L VIN U (2005)
5. Connect the electrical connector to the EBCM (3). Ensure the cam (2) is secured by the lock tab.
6. Connect the electrical connector to the brake fluid pressure sensor.
7. Install the two BPMV bracket-to-crossmember mounting bolts.
^
Tighten the bolts to 27 Nm (20 ft. lbs.).
8. Lower the vehicle.
9. Connect the negative battery cable.
10. If a new EBCM was installed, the EBCM must be programmed. Please contact your local dealer regarding this procedure. See: Testing and
Inspection/Programming and Relearning
11. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information.