Corvette V8-6.0L VIN U (2005)
drive components to verify that the components is operating properly.
5. This test is to verify that the drive belts tensioners is operating properly. If the drive belts tensioners is not operating properly, proper belt tension
may not be achieved to keep the drive belt from slipping which could cause a belt squeal noise.
6. This test is to verify that the drive belts is not too long, which would prevent the drive belts tensioners from operating properly. Also if the
incorrect length drive belts was installed, it may not be routed correctly and may be turning an accessory drive component in the incorrect
direction.
7. Misalignment of the accessory drive pulleys may be caused from improper mounting or incorrect installation of a accessory drive component, or
the pulley is bent inward or outward from a previous repair. Test for a misaligned pulley using a straight edge in the pulley grooves across 2 or 3
pulleys. If a misaligned pulley is found, refer to that accessory drive component for the proper removal and installation procedure for that pulley.
8. Inspect the accessory drive pulleys to verify that they are the correct diameter or width. Using a known good vehicle, compare the pulley sizes.
Drive Belt Vibration
Drive Belt Vibration Diagnosis
Diagnostic Aids
The accessory drive components may have an affect on engine vibration. An overcharged air conditioning (A/C) system, a power steering system
restriction, or the incorrect fluid, or an extra load placed on the generator are suggested items to inspect. To help identify an intermittent or an
improper condition, vary the loads on the accessory drive components.
